1 files changed, 13 insertions, 16 deletions
diff --git a/network/radvd/README b/network/radvd/README
index 9dc84d056d..826dea2906 100644
--- a/network/radvd/README
+++ b/network/radvd/README
@@ -1,22 +1,19 @@
 The router advertisement daemon (radvd) is run by Linux or BSD systems
-acting as IPv6 routers. It sends Router Advertisement messages, 
-specified by RFC 2461, to a local Ethernet LAN periodically and when 
-requested by a node sending a Router Solicitation message. These 
-messages are required for IPv6 stateless autoconfiguration.
+acting as IPv6 routers.  It sends Router Advertisement messages, specified 
+by RFC 2461, to a local Ethernet LAN periodically and when requested by a 
+node sending a Router Solicitation message.  These messages are required 
+for IPv6 stateless autoconfiguration.
 
-Radvd is dependant upon IPv6 support in the Linux Kernel; this comes
-enabled by default with Slackware 12's 'generic' kernel.  To enable
-IPv6 support manually, you must set the following entry in your 
-kernel's '.config' file and recompile:
-	CONFIG_IPV6=m
+Radvd is dependant upon IPv6 support in the Linux Kernel; this comes enabled 
+by default with Slackware 13's generic and huge kernels.  To enable IPv6 
+support manually, you must set the following entry in your custom kernel's 
+.config file and recompile: CONFIG_IPV6=m
 
-Once the Slackware package is installed, edit /etc/radvd.conf to
-reflect your current IPv6 configuration. 
-
-An init script has been provided at /etc/rc.d/rc.radvd.  
-To have radvd start at each boot, add the following lines to your
-/etc/rc.d/rc.local file:
-	# Start the radvd daemon:
+Once the slackware package is installed, edit /etc/radvd.conf to reflect 
+your current IPv6 configuration. An init script has been provided at 
+/etc/rc.d/rc.radvd.  To have this start upon each boot, add the following 
+lines to your /etc/rc.d/rc.local file:
+	## Start the radvd daemon:
 	if [ -x /etc/rc.d/rc.radvd ]; then
 	   /etc/rc.d/rc.radvd start
 	fi